ZOK mx Heavy-Duty Gas Turbine Compressor Cleaner – 25 Litre

ZOK mx is a concentrated, water-based, biodegradable gas turbine compressor and gas-path cleaner specifically formulated for heavy-duty cleaning requirements.

Its higher-pH formulation provides powerful cleaning performance for removing carbon, salt, oil, grease, atmospheric contamination, and other difficult deposits from compressor blades, Inlet Guide Vanes, and gas-path components.

ZOK mx is designed as an environmentally responsible alternative to conventional solvent-based cleaners. Regular online and offline compressor washing helps prevent long-term fouling, recover power output, improve fuel efficiency, reduce exhaust-gas temperatures and emissions, and extend the service life of gas turbine components.

Unlike ZOK 27, ZOK mx does not contain an added corrosion inhibitor. A water rinse and dry-out run are therefore recommended after cleaning, subject to the gas turbine manufacturer’s maintenance instructions.

ZOK mx is supplied as a concentrate and should be mixed at a ratio of one part product to four parts water, producing a 20% cleaning solution. Ready-to-use versions may also be available.

PERFORMANCE ADVANTAGES
• Heavy-duty gas turbine compressor cleaning
• Removes carbon, salt, oil, grease, and atmospheric contaminants
• Higher-pH formulation for challenging cleaning requirements
• Suitable for online and offline compressor washing
• Helps recover gas turbine power output
• Helps improve fuel efficiency
• Helps reduce exhaust-gas temperatures
• Helps reduce harmful emissions
• Helps extend component and equipment service life
• Reduces long-term compressor fouling
• Water-based and biodegradable
• Non-flammable formulation
• Alternative to conventional solvent cleaners
• Low ash content for hot-wash applications
• Suitable for aviation, industrial, offshore, and power-generation turbines

IMPORTANT PRODUCT DIFFERENCE
ZOK mx has a higher pH than ZOK 27 and is intended for more challenging or heavy-duty cleaning requirements.

ZOK mx does not contain an added corrosion inhibitor. A water rinse and dry-out run are recommended after use unless the equipment manufacturer provides different instructions.

COMPOSITION
A special blend of non-ionic surfactants, organic solvents, and demineralised water.

DILUTION AND DIRECTIONS
Mix one part ZOK mx concentrate with four parts water to produce a 20% cleaning solution.

For hot or online cleaning, use demineralised water with conductivity below 11 µS/cm.

For cold or offline cleaning, good-quality drinking water with conductivity below 500 µS/cm may be used.

Apply using a spray ring or lance during starter-driven offline washing or fired online washing. Follow the engine manufacturer’s maintenance manual for injection quantities and procedures.

A water rinse and dry-out run are recommended after cleaning. Antifreeze should be added when operating below +5°C, following the manufacturer’s recommended dilution.